Before starting painting work, it is definitely necessary to design the power supply, which is suggested by the specialists of the site www.montazhelectro.com.ua/proektirovanie.html. Then, according to the plan, lay the wiring and only then proceed to plastering and painting work.
When you start painting, you first need to pick up a brush. Better to take a brush that is made of pig bristles. The brush, which consists of bristles and horsehair, is slightly inferior. Next up is a brush made from horsehair. And the most substandard brush is nylon fiber brushes. And the price speaks for itself. The latest and cheapest from the list.
When choosing a brush, you need to pay attention to the length of the hair. If the hair is too long, then the paint will lay down in an uneven layer. Short hair will rake the dye behind it. It is best when the length of the bristles is equal to the diameter of the brush itself.
If the hair on the hand is long, then it can be shortened as follows. Take a plug of the right size, and insert it in the middle, and wrap the hair on top with a tourniquet. This way the brush will last longer. As the brush wears out, you can simply pull out the plug.
When painting a small surface, the brush can be replaced with foam rubber. To do this, you need to take a small piece and tie it to a stick.
If you've worked with PV varnish or paint and don't have a solvent on hand, put the brush in water. After a day, you can wash it in warm water with the addition of soap. If this method does not help, then the brush can be boiled with the addition of powder.
If the paint has thickened, then you can take a wire 5 - 8 mm thick, bend it, and insert it into the drill. In this way, thickened paint can be reanimated. Cover the jar with plastic or cardboard when working. Then the paint will not fly in all directions.
If a film has formed on the paint, then it must be filtered. But there is one way to avoid this. Take a simple stocking, dip it in the paint. Now you can just dip in the paint through it.
If the paint remained, then you can do this. Cut a circle out of cardboard, put it in a can of paint, and pour drying oil on top.
To find out the consistency of the paint, you need to drop a little paint on the dry glass. It should flow down the glass by 35 - 50 mm.